(No Longer Available as of September 30, 2005) The IBM ThinkVision L171p LCD flat-panel monitor has the following Note: Total maximum of #4962 and #5706 with #0961 is 2. #0961 and #5706 The IBM 2-Port 10/100/1000 Base-TX Ethernet PCI-X Adapter is a Full A function called 'Large Send' or sometimes known as TCP Segmentation The IBM 2-Port 10/100/1000 Base-TX Ethernet PCI-X Adapter (#5706) Note: For optimum performance, the adapter should be placed in a Limitations: The 1000 Mbps speed is not supported in Half Duplex Note: Total maximum of #4962 and #5706 with #0961 is 2. #0961 and #5706
41a947,979
(#3640) - IBM ThinkVision L171p Flat Panel Monitor
general characteristics:
(17.0 inches) measured diagonally, incorporating a 0.280mm pixel
pitch/type for bright, high-definition images.
026a1065,1066
are MES only.
042a1083,1127
(#5706) - IBM 2-Port 10/100/1000 Base-TX Ethernet PCI-X Adapter
Duplex, dual ported, Gigabit Ethernet adapter designed with highly
integrated components. This adapter can be configured to run each port
at 10, 100, or 1000 Mbps data rates. The adapter interfaces to
the system via a PCI or PCI-X bus and connects to a network using a
4-pair CAT-5 Unshielded Twisted Pair (UTP) cable for distances of
up to 100m. AIX Network Install Manager (NIM) boot capability is
supported with this adapter. The adapter conforms to the IEEE
802.3ab 1000Base-T standard. The adapter also supports jumbo
frames when running at the 1000 Mbps speed.
is also provided by this adapter. This function offloads the TCP
segmentation operation from the AIX IP layer to the adapter for
outgoing (transmit side) TCP segments. Another function known as
"Checksum Offload" which offloads the TCP/UDP Checksum Operation
or workload from the CPU to the adapter is also provided.
should be considered where maximum port density is required per I/O
card slot. For a suggested maximum number of adapters taking
performance into consideration, refer to the RS/6000 & pSeries PCI
Adapter Placement Reference SA38-0538.
If card slots are not the limiting factor and maximum
throughput is required, the single port IBM 10/100/1000 Base-TX
Ethernet PCI-X Adapter (#5701) is the preferred solution.
64 bit PCI-X card slot whenever possible.
(HDX) mode.
connections to Gigabit Ethernet LAN(s).
are MES only.